Add an IP endpoint (Edify Console)
Edify Console > Account > IP Endpoints > Add an IP endpoint (Edify Console)
This article explains how to add an IP endpoint in Edify Console.
Steps
1. Log into Edify Console at console.edify.cx.
2. Navigate to Account > IP Endpoints.
3. Click the New Endpoint button in the top-right corner of the screen.
4. Fill out the Create IP Endpoint modal that appears, including:
The name of the IP endpoint
The MAC address of the endpoint (usually located on the bottom or back of the device)
Who the endpoint should be assigned to.
5. Click Save in the bottom-right corner of the Create IP Endpoint modal.
6. Once you click Save, you’ll be presented with a configuration page for the IP Endpoint.
7. Click the pencil icon in the top-right corner of the Endpoint Settings container to configure the endpoint.
8. In the Endpoint Settings container, configure the following fields:
Name: Create a nickname for the endpoint.
Type: Choose the make of your phone.
Model: Choose your phone’s model from the dropdown menu.
Phone Label: A short description of the endpoint.
MAC: The MAC address of the endpoint (usually found on the bottom or back of the device)
Serial Number: The serial number of the endpoint (usually found on the bottom or back of the device).
Assign To: (if applicable)
Location: Choose the office location your phone will be located at.
Time Zone: Select the time zone the phone will be in.
Encrypted Calling: Select whether you want calls to be encrypted.
Allow Hot Desking: Select whether you want the phone to support hot desking.
Template: Assigning a template to the endpoint will pull settings from the template, including the endpoint’s general settings and network settings.
Endpoint Settings container
9. Click Save.